Most of us could use more closet space. One way you can optimize the closet space you have is to install a closet rod. You can incorporate a hanging rod in a closet that has either low or high shelving, and you can place two hanging rods in a closet if you desire. Offset multiple rods (depending on the depth of the closet) to hang clothing full-length on one bar while hanging additional items on a lower rod. The possibilities are numerous. Does this Spark an idea?
Instructions
1. Determine the type and amount of clothing that will be hanging on a given rod. Choose your rod and anchor braces after considering the weight of the clothing they'll support. Adjustable rods can be used for lightweight hanging without brace anchors, while an adjustable rod with brace anchors can be used for heavier clothes. For coats and jeans, a wooden rod is recommended.
2. Remove all other items from the closet to optimize your work space. Use a stud finder to locate studs to anchor the rod or rods. If studs are not available, you may need to rethink what you'll be able to hang securely on the rod. Screw anchors can be used in drywall, but these provide limited support.
3. Use a measuring tape to measure your desired height for the closet rod; 65 to 68 inches will suffice for full-length clothes, while 38 to 40 inches will do for a low rod. If you're going to install more than one rod, raise the top rod up to 75 to 80 inches. Mark the measurements on the closet wall with a pencil.
4. Measure the depth of the rod from the back closet wall. Allow at least 12 inches from the wall for the clothes to hang properly. Coincide the depth measurement with the height measurement and this will be the brace anchor position for the rod.
5. Install the brace anchors using the required hardware and a screwdriver. If you're installing to drywall, drill a hole that is a bit smaller than the screw anchor, and then tap the screw anchor in with a hammer. Align the brace anchor screw holes with the screw anchors and install the screws. If you're installing to studs, drill a small pilot hole for the screws and then align the brace anchor before inserting the screws.
6. Hang the rod on the brace anchors and test its durability before hanging clothes from it. Pull down on it to make sure it's secure.
7. Repeat Steps 3 through 6 for a second rod if desired. Don't hang clothes on the first rod until you're finished installing the second rod. Hang your clothes when you're finished.
Tags: brace anchors, brace anchor, anchors used, closet space, closet wall, inches will, screw anchor
